Discussion:
Access97 Install
(too old to reply)
Jim
2013-09-28 17:27:06 UTC
Permalink
Windows XP - just reinstalled
Dell Dimension 251

I have followed as far as possible the advice at
http://bytes.com/topic/access/answers/206045-error-cant-create-system-mdw

So - taking out a memory module I got down to 1 gig of RAM and Access 97
finally installed without the problem "unable to access SYSTEM.MDW "

The install then began start up but gave the "Out of memory" issue".

I can't get my RAM dowm any lower - the remaining module is 1 gig.

Installed Office 2000 - which oprovides a later copy of JET hoping that this
might cure the problem.

No Go - Access 2000 runs ok BUT Access 97 > Out of Memory.

I can't get back to pre Service Pack 2 as advised on the link above (my
windows installation Disc includes Service Pack 2)

Is there anything I can do to my Access 97 install to persuade it that it
has memory enough?

[It's only about 3/4 yrs ?at a guess? since I last reinstalled to get rid of
a Virus issue - at that time Access 97 installed Ok and then I put Office
2000 over the top of it. I certainly had 2gig Ram at that time]

Jim Bunton
AaronKempf.com | CareerDBA.com | FullStackWP.com
2021-01-11 10:49:06 UTC
Permalink
you just need to get that damn database up to version 2000 or newer. I'd reccomend 2007 or 2010 but not any newer than that.
Continue reading on narkive:
Loading...